- #Anilam series 1100 control homing procedure how to#
- #Anilam series 1100 control homing procedure manual#
As soon as the second chunk of program is being executed the control shuts down sometimes with Lag error, other times with no error message. The change in position of the table while the control is reading the next segment does not register on the readout. The issue I have is that while it's reading the second segment, the control is not holding position and the table actually drifts at a slow speed. It then prompts my PC for more and reads the second segment of program. The next time you post-process a toolpath from inside the CAM plug-in. spm file) and move in into the corresponding folder under the Posts folder under the CAM plug-in installation folder. To use post-processor from the list, download the post (a. The control reads and executes the first segment of code just fine. The following is the list of post-processors that will work with MecSoft CAD/CAM Software products. This would effectively be the end of first segment of code and the beginning of the second. I broke down the program into segments by simply insterting two two lines of % symbols in the middle of the program.
#Anilam series 1100 control homing procedure how to#
I have been learning how to set it up so it can run programs larger than the memory can hold.
#Anilam series 1100 control homing procedure manual#
Unless another Controller series is specified, the operating procedures and screen captures used in the manual are examples for the NJ-series Controllers.
I have an Anilam Crusader Series M controller fitted to a knee mill. The Sysmac Studio supports the NJ/NX/NY-series Controllers.